Wolf's Den

I'll try to remember to ask my son if he has any advice tonight
I appreciate it!

I did buy couple of upgrade parts. Like yellow springs and better gears for the heat bed. I'm waiting for Amazon to deliver them.
 
I fully assembled it last night. I haven't tested it out yet and I do have two issues.

The heat bed a bit wobbly and the right side z-axis passive block wheels are a bit loose and it's affecting the arm.
My son says the Ender 3 v2 is "the best one".

The bed wobble "is completely normal, it's due to the tensioning springs being compressed when you wiggle the bed plate. That doesn't happen while it's printing. Just make sure you have a spring under each of the four corners of the print bed."

For the arm having a hard time going back up "this is normal. It doesn't prevent the printer from working but it sucks for calibration. If you want you can loosen these two screws, but only a little bit. It doesn't have to be half out. Maybe a half-turn."

Clipboard01.webp

For the right side z-axis passive block wheels, "I'm guilty of having that loose too but it's never been a problem. But if you want to fix that, try tightening this screw. Thanks for remind ME to tighten that one."

View from the back, behind the power supply....

Clipboard02.webp
 
Thanks for your suggestions @sadchild. I was able to get the heat bed wobbly issue resolved. The eccentric spacers needed tightening and same for the V slot. I was able to power it on and get everything set up. Later today I will do my first test print.

When I turned the unit on, I took a quick pic and then placed the heat bed glass with bed clips.

FOgYxWwVgAAoNDA
 
My son says, "Wow I didn't realize my eccentric spacers under the bed needed to be adjusted. I didn't realize that was a thing until you brought it up."
 
Now I need to buy certain color filaments and can't wait to print these one day. :laugh:

il_fullxfull.2604982729_hsvp.jpg
 
Wolf are you currently on fire?

Who could ever imagine that a place as hot and dry as hell on earth would have wildfires?

And BTW, there's a thread for that

 
Last edited:
And BTW, there's a thread for that

How dare you!?!

This is the correct thread. I was asking if specifically Wolf, the man, is currently of fire. Not if there are wildfires in his area right now.

I just wanted to make sure he remembered to stop, drop and roll if that happened to be his current situation.
 
How dare you!?!

This is the correct thread. I was asking if specifically Wolf, the man, is currently of fire. Not if there are wildfires in his area right now.

I just wanted to make sure he remembered to stop, drop and roll if that happened to be his current situation.
Please accept my sincere apology.
 
Back
Top Bottom